I converted my project from V1.5 to 2.0. If I resize my screen now, when it gets smaller, it does not convert from two column to one column after a breakpoint.

How to correct this?

Regards, Linda

Please post a link to your project file.

https://www.dropbox.com/sh/ixsyzruilp4d … -7gza?dl=0
En the V2.0 website www.qtouch.nl

Regards, Linda

This is probably related to your other issues. Because this was created with Bootstrap2 through RLM, the wireframe is not a part of RSD 2.0. Just like where you had to re-apply your button styles, you need to adjust your SPANS as well.

If you look at the lowest breakpoint and select any element that is showing it two columns, go the Layout pane, and you will see the SPAN widths are set to 6. You need to change those to 12. And further down, they are set to 4 spans and you need to change those as well to 12.

You might keep running into these oddities because this was created in a much older version of Bootstrap. It may be worth your while to start over and re-build in Bootstrap 4.

Thanx, going to fix it.

If I change it to 12 columns and than go back to a higher breakpoint it doesn't snap to 6, but it stays 12, what am I doing wrong?

Probably the same issue. You have to reset them on each breakpoint.

Use this one. I deleted all the white breakpoints as they didn't have any styles. On the lowest breakpoint I set the spans to 12 and the on the 767px breakpoint, set them back to 6.

https://www.dropbox.com/s/rmrl3ivaqteb0 … 5.rsd?dl=0

Arrrghhh, I understand, but struggle to take that step, but I keep smiling. ????
Thanks for your support, I appreciate it.

Just a thought -

There seems to be a columns glitch in RSD2 beta build 1965, which Adam is reviewing in my Support Room. Basically the problem is where, in the Layout panel, the RSD1.5 project file did not have the default figures for the number of Columns and Gutter(px).

Frank

My 1.5 project had 12, 32. And the 2.0 project gives 12, 16. So maybe wait for the update?